Our Mk 2 guillotine for has been designed for you to accurately cut styrene strip.
Supplied with a selection of guides and a replaceable cutting slot.
As it wears down under the blade just turn it over or remove and slot in another.
The guillotine is approximately 20 cm wide by 14 cm deep.
Fitted with a heavy duty handle. Fully adjustable.
Comes with 2 alignment jigs and hold down bar plus 2 spare blades.
Colours may vary from those shown.
Design may be altered slightly for improvement.
Replacement parts are available.
Instructions that come with the guillotine are repeated below.This Guillotine is designed for cutting thin plastic strips such as those made by Evergreen, Styrene, Plasticard or Plastrut. It's also suitable for thin strips of Balsa.
The centre cutting area is is replaceable once you’ve worn it down.
If the alignment of the bar has moved during transit just loosen the appropriate hardware and re-adjust slightly.
To replace the blade use a cutting strip or 2 as a spacer across under the front handle to ensure the blade holder is horizontal. Then press a new blade down flush with the cutting surface and ensure the bolts are really tight.
When the strip is worn out gently remove it and slot in a replacement.
When cutting angles or for repeated cutting to a specific length use one of the supplied alignment jigs. They are held in place with the spring bracket. See the pictures of the unit in use
Spare blades, cutting strips and alignment jigs are available.
Showing 1 to 6 of 6 (1 Pages)